CREATE ACCOUNT

ULTRASONIC THICKNESS
TESTING (UTT)

Manual, contact, pulse-echo ultrasonic testing is a mainstay of pipeline direct assessment. Thickness testing, lamination scans and corrosion evaluation of localized areas are common applications wher large scale AUT or other applications may not be necessary.

Ultrasonic Straight Beam and other ultrasonic NDT flaw detection techniques utilize sound energy in the testing procedure.  Straight beam testing utilizes the concept that sound energy traveling through a medium will continue to propagate until it either disperses or reflects off a boundary of another material.  Air surrounding a far wall or the gap created by a flaw or like discontinuity are examples of material that causes reflection of the sound energy. In this type of test, the operator pairs the transducer to the test piece and identifies the echo returning from the far wall (known as 'the backwall signal').  After identifying the backwall signal location on a good part, the operator then looks for any additional echoes that appear ahead of the said signal or watch for the signal to shift when inspecting a test piece. An acoustically significant echo that precedes the backwall signal may represent the presence of a laminar crack or void. Through further analysis, the depth, size, and shape of the structure producing the reflection can be determined.

Normal/Angle Beam – Normal beam testing uses a sound beam that is introduced at 90 degrees to the surface – for thickness testing, while angle beam utilizes a beam that is introduced into the specimen at some angle other than 90 degrees. The choice between the two is made based on the orientation of the discontinuities that are of interest to the inspector, as the inspector should always try to introduce the sound beam at an angle as close to perpendicular the discontinuities primary axis so that the maximum amount of sound reflection occurs.

Applications for Ultrasonic Straight Beam testing:Ultrasonic Straight Beam

  • Flaw detection such as parallel cracks, inclusions, porosity, laminations, etc

  • Erosion/Corrosion thickness gauging and mapping

  • Assessment of bond integrity

Advantages of Ultrasonic Straight Beam Testing:

  • Detects surface and subsurface discontinuities

  • Superior representation of depth of penetration vs. other test methods

  • With a pulse-echo technique, only one sided access is required

  • Accurately estimating discontinuity size and shape

  • Minimal surface prep is needed

  • Immediate results produced by using electronic equipment

  • It can be automated.  Automated testing results in detailed images

Limitations of Ultrasonic Straight Beam Testing:

  • Surface must be accessible

  • Requires couplant to promote sound transfer

  • Surface roughness, certain castings, or exceptionally thin materials are difficult to inspect

  • Linear defects oriented parallel to the sound beam go undetected

CONTACT US ABOUT NDT AND INSPECTION SERVICES

Call 785-455-2027 for immediate assistance

XCEL Services

With offices geographically located throughout the central United States, XCEL is here to serve you.

TOP